Welcome!
Congrats On Your New Custom Set!
All Sets That Are Not Already In Stock Require Some Simple Assembly
The Videos Below Will Assist You To Safely Assemble The Bowls
Please Watch The Correct Video For Each Set That you Have Purchased
(Please Do Not Even Unpack The Magnets Prior To Watching The Videos)

Quick Assembly Steps
Step 1: Open Bottom 1 Package
Step 2: Remove Red Cover On Sticky Pad
Step 3: Place In The Centre On The Bottom Of The Bowl
Step 4: Open Inside 1 Package
Step 5: Grip Tightly & Slowly Place In The Middle Of The Inside Of The Bowl
Step 6: Slowly Remove Your Finger So It Lands As Softly As Possible
Repeat Step 1-6 For All Bowls

Important Magnet Polarity Info
Bottom 1 And Inside 1 Magnets Go Together On The Same Bowl
Bottom 2 And Inside 2 Magnets Go Together On The Same Bowl
They Are Polarized Opposite To Each Other
If You Want 2 Bowls To Go On A Double Bowl Handle
Then They Must Be The Opposite Polarity To Each Other
If You Want 4 Bowls To Go On The Sides Of A Spinner
2 Bowls Must Be Inside 1/ Bottom 1
And 2 Bowls Must Be Inside 2/Bottom 2

Wall Plate Instructions

Please Watch Video Below To See A Visual Of How It Will Look
Step 1: Clean The Wall To Remove Dust And Debris
Step 2: Remove Film To Expose Sticky Side Of Plate
Step 3: Hold Against The Wall For 20 Seconds
Step 4: Put Thumb Tack On Each Straight Side Of The Plate
Step 5: Place The Bowl On The Wall Slowly And Carefully
Please Note: This Works for Thin Crystal Bowls Only
Ie. Not Frosted Bowls, Crystal Tones, MoS XL Bowls Or Specifically Stated THICK BOWLS